Standing seam and metal panel roofing, roof repair and full replacement in Nooksack. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Nooksack.
New skylights set into metal or shingle roofs, with the flashing kit the roof actually calls for rather than a tube of sealant.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
A metal roof is the one that outlives the mortgage. We install exposed fastener panels and standing seam over solid decking and real underlayment, with around twenty standard colors to choose from.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
A twenty year old panel roof usually needs fasteners and sealant, not replacement. We refasten with new washers and get you another long stretch out of it.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
When a roof is genuinely finished we replace it, and we say so plainly rather than dressing it up. Metal and shingle priced side by side so you can compare real numbers.
From a few tabs to a whole slope, we fix shingle roofs without pushing you toward a replacement you are not ready for.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
Not every hailstorm ruins a roof. We look before we tell you anything, and if the damage is only cosmetic we will say that too.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Nooksack homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Nooksack home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Nooksack homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
The questions that come up on just about every estimate we write.
Sometimes. If the decking is sound and there is only one layer of shingles, a Nooksack metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
For most Nooksack homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Most Nooksack metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Plenty of them. Most Nooksack customers choose from around twenty standard colors, and green, burgundy, bronze, black, gray, tan and barn red are the ones people pick most. We bring the color chart out with the estimate so you can hold it up against your siding.
No. Estimates are always free in Nooksack. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
Any dry stretch works. We roof in Nooksack year round, though we schedule shingle work for when it is warm enough for the strips to seal properly, and we watch the forecast so your house is never left open overnight.
Real feedback from homeowners whose roofs we have worked on.
"Tore off two layers of old shingles and found rotten decking underneath. They showed me the boards, told me what the change would cost, and let me decide before going ahead."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"They roofed our addition and tied in the porch that runs off it. One crew, one number to call, and every line of it matched up."
Our crews cover the surrounding area, not only the city limits.